Home / Shop / Adjustable Heavy-Duty Tripod Stand
Photos for this item are being shot now — check the specs and fitment notes below, or email us and we’ll send real photos of the exact part before you order.
Adjustable Heavy-Duty Tripod Stand
For RVs, campsites, rentals and anywhere you'd rather not put a hole in the building.
$62.99
Secure checkout via Payhip · Free US shipping over $49 · 30-day returns
Fits: Fits Standard (Gen 3 / V3 / Standard 4) and Mini via the 1.5" pipe thread.
- ✓Freestanding — nothing drilled, nothing bolted down
- ✓Height-adjustable mast clears fences, RVs and low walls
- ✓Three folding legs, each adjustable, so it sits level on rough ground
- ✓Folds down flat for transport and storage
- ✓Powder-coated steel with stainless hardware
Specs
| Compatible dishes | Standard (Gen 3 / V3 / Standard 4), Mini |
|---|---|
| Mount type | Freestanding tripod — no drilling, no roof penetration |
| Mast interface | 1.5 inch pipe thread |
| Legs | Three folding legs, independently adjustable |
| Finish | Powder-coated steel |
| In the box | Tripod, mast, hardware set, printed instructions |
Fitment & install
Full step-by-step instructions ship in the box. If anything is unclear, email us a photo of your setup and we'll walk you through it.
- ✓Stand it where the sky view is clear, level the legs, then set the dish on the mast.
- ✓Typical setup time: under 10 minutes.
- ✓Nothing is fastened down — pack it up and take it with you.
Before you order
Do I need to drill?
No. It's freestanding — you set it down, level it, and you're done. That also means there's nothing to undo when you move on.
Will it work with my dish?
Yes for both current dishes — the mast uses the same 1.5 inch pipe thread. If you have an older round dish, message us first and we'll confirm before you order.
Where does this make the most sense?
RVs, campsites, rentals, job sites, tailgates — anywhere you can't drill, or anywhere the dish travels with you. If the site is permanent, a roof mount or wall bracket is the better answer.
What happens in high wind?
Any freestanding stand has a limit, and we'd rather tell you than have you find out. Take it down before a storm — that's the trade-off for not drilling holes.
What does shipping cost?
Free over $49, flat $6.95 under that. Alaska and Hawaii may cost a little more, and we'll always tell you before charging anything.
Others in the range
Low-Profile Roof Mount Kit
Low-profile roof mount that holds its position through high wind, snow load and heavy rain.
Wall & Eave Bracket
The clean way to get a clear view of the sky without putting a hole in your roof.
Router Wall Mounts
A slim wall bracket for the Gen 3 router, so the power lead and cables stop living on the floor.